![]() Connect to the device using IP address that was previously noted.ĭAKTRONICS DOES NOT PROMISE THAT THE CONTENT.Adjust laptop IP address, if necessary, to match the first three octets of the discovered device.Make note of the IP shown that is not your laptop.Any IP addresses detected on devices (including your laptop) will be listed under the "Address" column.Click the "IPv4" or "IPv6" tab depending on device.Click the End points option from the drop down.Click the "Statistics" tab from the menu across the top.Power on the DMP, VIP, or 6000 series device (the monitor window should start to show network traffic). ![]() A monitor window will appear that will show network traffic (it may be blank until powering on the device).Click the "Start" button located above the network adapter list or select Start under the "Capture" menu.If no adapters are listed, WinPcap may not have been installed and will need to reinstall WireShark.Open Wireshark and select the network adaptor that will be used to connect to the device from the area shown below (both the old and new versions are shown).Connect the Player or Video Processor directly to the laptop using an Ethernet cable.Install Wireshark software on the laptop that will be used to find the Daktronics player or video processor device.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |